Spring-Loaded Cleat, each
Item No. 314454
Spring-Loaded Cleat, each is rated
out of
5 by
5.
Images
Details
https://www.overtons.com/spring-loaded-cleat-each-314454.html
Spring-Loaded Cleat, each
$26.99
$29.99
Save $3.00
(
10% Off
)
Additional Information
Features
Low profile cleat is easily installed from the top in just minutes. Great for hanging fenders, attaching dock lines and rafting, the 1-1/4" cleat practically disappears when in the down position. A simple turn locks it in the up position.
Show moreShow less
- Instals in just minutes
- Great for hanging fenders, attaching dock lines
- 1.25" long
- Stainless steel
Specs
| Unit Weight | 0.50 lb |
|---|---|
| Brand | Whitecap |
Reviews
Q & A
Low profile cleat is easily installed from the top in just minutes. Great for hanging fenders, attaching dock lines and rafting, the 1-1/4" cleat practically disappears when in the down position. A simple turn locks it in the up position.
Show moreShow less
- Instals in just minutes
- Great for hanging fenders, attaching dock lines
- 1.25" long
- Stainless steel
| Unit Weight | 0.50 lb |
|---|---|
| Brand | Whitecap |
Rated 3 out of
5
by
Jerry from
Good design -- just incomplete
The cleat itself is fine, after boring a hole in the side of my jet ski, I felt I needed a gasket to prevent/reduce water inflow. so I had to make one. Also does not come with mounting hardware, i.e screws or nuts, I used pressure nuts so they wouldn't back off easily. With the gasket in place it seems to work fine. Just the extra hassle of having to go get gasket material and mounting hardware. For $29.99 seems it should come with that.
Date published: 2014-08-18
Rated 2 out of
5
by
Captain Randy from
Installation
Unfortunately this cannot be installed without having access to the back of the installation location. Nobody, not even the manufacturer's hotline could answer that question before ordering. Could have been terrific but not for my purpose as a fender tie off.
Date published: 2013-04-02
Rated 5 out of
5
by
Frankie from
This is a great product!
I put one on each side of my pwc , makes it a lot easier to tie off at the docks!
Date published: 2013-01-20
Rated 5 out of
5
by
Boyce from
Easy to install and they work great.
Installed these on my previous boat and I am ordering a set for my new boat. They are great for locating bumpers where they are needed to prevent scraches.
Date published: 2010-08-28
Rated 1 out of
5
by
Mike from
I returned this product
You cannot get to the head of the screw to fasten to deck.
Date published: 2010-06-10
What is the distance in inches from the bottom of the flange to the bottom of the shaft that the spring wraps around? Another way to say it is how deep does the cavity need to be that this mounts in? Thanks for the reply.
It will be about an 1.25 inches deep from the flange of the cleat.
Date published: 2015-09-23