Springfield KingPin Threaded Square Steel Base
Item No. 315859
Images
Details
https://www.overtons.com/springfield-kingpin-threaded-square-steel-base-315859.html
Springfield KingPin Threaded Square Steel Base
Springfield KingPin Threaded Square Steel Base is rated
out of
5 by
6.
Item No. 315859
$33.24
$34.99
Additional Information
The innovative design of the Springfield Control Post lets it easily be adjusted for comfortable use as a seat or leaning post. Keep the seat upright for enhanced lower back support or angle it to take the pressure off of your legs. The seat rotates to keep up with your changing casting angles. The corrosion-resistant power rise pedestal has an up/down level for instant height adjustment from 28-1/2" to 35-1/2".
Threaded Square Base is made of stainless steel with a satin finish. Below the deck mount requires a 2.5" dia. hole in deck. 7" x 7" with 4" deep cup.
Show moreShow less
Threaded Square Base is made of stainless steel with a satin finish. Below the deck mount requires a 2.5" dia. hole in deck. 7" x 7" with 4" deep cup.
Springfield KingPin Threaded Square Steel Base is rated
out of
5 by
6.
Rated 5 out of
5
by
avenger99 from
butt seat
It was what I needed for my seat to fish from to complete my seat to fish from. So I bought it.
Date published: 2017-03-14
Rated 5 out of
5
by
zoniezz from
A snap to install
Installed it on the front deck of my 15' Jon Boat. Used for sitting and operating the trolling motor.
Date published: 2012-10-09
Rated 5 out of
5
by
Dan from
Reasonably priced and good quality
I use the pedestal base for the rear fishing seat in a crossover bass boat. I'm hoping that the base is resistant to saltwater since the base is mounted on top of the rear live well and is subject to constant contact with saltwater. It is a ten minute job to switch it out so if it lasts a few years I'm happy. The original base is the same make and lasted ten years.
Date published: 2012-09-19
Rated 5 out of
5
by
Ringkitty from
Easy To Install
This seat base was easy to install. Took about 15 minutes to install two in the front of my bass boat. Going to use them for spider rigging. You will need a 2 3/4 inch hole saw and some SS screws. Very sturdy I weigh 375+. Now that's a test.
Date published: 2011-12-30
Rated 4 out of
5
by
Fish from
works great
for fishing
Date published: 2011-06-22
Rated 4 out of
5
by
big mouth frog from
sturdy
pontoon
Date published: 2011-06-11