Power Watchdog Gen II Replacement Surge Module for 30-Amp WiFi Surge Protector
$39.99
FREE Shipping over $99
Estimated delivery in 5-7 days
Estimated delivery in 5-7 days
- In Stock
- Delivery to Change Address
- Delivery Fee Details
This item is excluded from all discounts and promotions.
Minimum order quantity of
1
Maximum order quantity of
100
Must purchase in increments of
1
Special Offers
Take $30 off $199+ with: CYBERWEEK
Take an EXTRA $30 off your order of $199+ with code: CYBERWEEK added to cart. Some exclusions apply. Not combinable with other promotions. Greatest discount will be applied in cart. Offer valid 12/4-12/7/25.
Return Policy
We believe in offering the very best value, quality, and selection. Plus, we want you to enjoy your purchase! In the event you wish to send a product back to us, you may return most unused items for a refund or exchange, minus shipping, within 90 days from the date of purchase unless noted below under exceptions and exclusions. Refunds are issued to the original form of payment.
Features
The Power Watchdog Gen II 30A WiFi Surge Protection Module is a replacement surge protection module that's designed for use only with the PWD30EPOW, PWD30EPOHW, and PWD30W Power Watchdog Gen II Surge Protector units. This model is designed for use only with the 30-Amp Generation II WiFi unit.
NOTE: This is not compatible with Gen I units.
SIMPLE INSTALLATION
• The only tool required is a Phillips screwdriver.
• Make sure unit is fully disconnected from any power prior to installation.
• Unscrew 6 Phillips screws on the back of the unit (7 screws for the EPO versions).
• Unscrew the top cable gland nut and move it up the cord.
• Carefully, separate the two halves of the body.
• The surge module slides in/out of the slot.
• Unclip the one red/black wire and loosen the screws holding the fork wire connectors to the wire leads.
• Disconnect the old surge module from the unit.
• Connect the new surge protection module and wires. “G” is ground and green color, “N” is neutral and white color.
• Replace all the screws and re-tighten the cable gland nuts.
This replacement surge protection module is only for the 30 Amp WiFi units: PWD30W, PWD30EPOW, or PWD30EPOHW.
NOTE: This is not compatible with Gen I units.
SIMPLE INSTALLATION
• The only tool required is a Phillips screwdriver.
• Make sure unit is fully disconnected from any power prior to installation.
• Unscrew 6 Phillips screws on the back of the unit (7 screws for the EPO versions).
• Unscrew the top cable gland nut and move it up the cord.
• Carefully, separate the two halves of the body.
• The surge module slides in/out of the slot.
• Unclip the one red/black wire and loosen the screws holding the fork wire connectors to the wire leads.
• Disconnect the old surge module from the unit.
• Connect the new surge protection module and wires. “G” is ground and green color, “N” is neutral and white color.
• Replace all the screws and re-tighten the cable gland nuts.
This replacement surge protection module is only for the 30 Amp WiFi units: PWD30W, PWD30EPOW, or PWD30EPOHW.
- Replacement module for PWD30EPOW, PWD30EPOHW, PWD30W Gen II Surge Protector
- Designed for use only with the 30-Amp Generation II WiFi units
- Not compatible with Gen I units
- Simple installation only requires a Phillips screwdriver
Specs
Unit Weight
0.11 lb
Brand
Hughes Autoformers
MFG Part No.
RSM30W
800-700-1366
