EEz-In Outboard Transom Platform with Two-Step Telescoping Ladder
Item No. 314272
Images
Details
https://www.overtons.com/eez-in-outboard-transom-platform-with-two-step-telescoping-ladder-314272.html
EEz-In Outboard Transom Platform with Two-Step Telescoping Ladder
EEz-In Outboard Transom Platform with Two-Step Telescoping Ladder is rated
out of
5 by
20.
Item No. 314272
$179.99
$199.99
Compare at $249.99
Additional Information
The sturdy, space-saving design of EEz-In Platforms and Ladders makes them an outstanding choice for boarding your boat. The high-density polyethylene platform is supported by 1" stainless steel rails. Ladders are made of stainless steel with poly-comfort flat steps. Single handrail leaves room for the outboard motor to turn. The handrail can be mounted on either side of the platform, so the platform may be placed on either side of the outboard motor. Platform measures 18"W x 15-1/2"D. 275-lb. capacity. Two-step ladder telescopes and stows out of the way underneath the platform. 11-1/4"W x 23-1/2"L deployed. Mounting hardware not included.
Show moreShow less
EEz-In Outboard Transom Platform with Two-Step Telescoping Ladder is rated
out of
5 by
20.
Rated 5 out of
5
by
mike the fisherman from
very well built , instructions suck. I would buy again.
very well constructed, looks very good on my boat. Instructions are very poor
Date published: 2015-05-28
Rated 5 out of
5
by
RICK from
UNEXPECTED QUALITY
THE PLATFORM IS PRESTAMPED FOR ALIGNMENT OF HOLES TO FIT MOST ANY SITUATION. THE HARDWARE IS ALSO CAPABLE OF BEING USED IN MORE THAN ONE WAY.THE BOAT I MOUNTED THIS PLATFORM TO WAS A 2003 CENTER CONSOLE THAT HAD A FACTORY PLATFORM CUT OFF LEAVING THE SHARP STAINLESS PIPES AND HARDWARE. I WAS ABLE TO ADAPT THIS PLATFORM TO A PERFECT FIT AND THEN ADD AN ADDITIONAL BRACE (IN THE KIT FOR A DIFFERENT SETUP). WITH A LITTLE BENDING AND MODIFICICATION IT WAS PURE QUALITY.
Date published: 2015-05-12
Rated 5 out of
5
by
Jane-Bowstring from
16.5' boat tight fit
Should have bought 3 step. Had to install higher than waterline.
Date published: 2015-03-17
Rated 3 out of
5
by
nik from
Very hard to install.
This ladder has little-to-NO instructions. The pre-drilled holes did not go all the way thru the platform, and they were not thick enough for the bolts so new pilot holes had to be drilled anyway. The brackets had no instructions and was no clear at all specifically where to attach them. Also - all other platform ladders have the ladder attach to the TOP of the platform so it doesn't come lose during travel. These attach to the bottom, which seems like it will be a problem down the road. And finally - the way the ladder secures to the platform seems problematic. it only secures using Velcro which will wear out quick in salt water. On a POSITIVE note - the materials are very solid and sturdy. The stainless pipe is strong and the actual platform is very thick and rugged.
Date published: 2014-08-21
Rated 5 out of
5
by
fish getter from
Very impressed would buy again
It is very sturdy and really well built. I am very pleased and impressed :)
Date published: 2014-06-13
Rated 5 out of
5
by
LKTOMWALLEYE from
If you build it, it will hold you!
Very high quality ladder. Installed on my 2012 Alumacraft Trophy 185. I'm 6ft 220 and it doesn't even show signs of flexing with me on it. Be sure to purchase stainless fasteners for the boat side, along with a marine grade sealant. Only wish I had more time to use it!!!
Date published: 2012-06-19
Rated 5 out of
5
by
boater from
Great product
Was hard to get my young kids back into the boat with my old hang over the side ladder. This ladder, My 2 year old girl could climb up by herself. Very impressed
Date published: 2012-02-09
Rated 4 out of
5
by
papayak from
Well satified with this unit
This unit was a snap to install. it sits at just the right level to make boarding a breeze. The only hitch is stowing the ladder it is diffecult to secure, a better method is needed.
Date published: 2011-08-25
what is the overall height of the mounts?Top attachment hole to bottom attachment hole. yhank you
13.5 inches apart
Date published: 2017-09-20
Is mounting hardware included? If not, what type of hardware is needed? When mounting, does one simply screw in mounting screws, or does one drill all the way through the hull with a bolt and nut assembly?
Mounting hardware is not included. We are required to leave mounting this ladder up to the customer. So, you can mount it either way you want, because both ways can be correct. It depends on your particular application.
Date published: 2015-09-23
what is the length of the lower bracket from under platform to mounting position
13 inches
Date published: 2015-09-23
Screws? I don't want to sound skeptical, but I have trouble believing screws could support something that is supposed to hold 275 pounds. Are you sure they won't come out? Is the hole large enough, or could I make it large enough, for a bolt?
Please contact our technical department at 1.800.334.6541 for further assistance.
Date published: 2015-09-23
will it fit on a boston wahler 18'?
These are universal ladders, not designed to fit on any specific type of boat. If you have space on your transom, the ladder will work.
Date published: 2015-09-23
Does this mount with screws or bolts? If bolts, what size?
You could actually mount this with number 10 self tapping stainless steel screws.
Date published: 2015-09-23
will this fit a 1987 stratos
If you have a similar question to this one please realize that this ladder is not boat specific and would require measuring your existing space allotted for the ladder before ordering. Please contact the technical department at 1-888-683-7866 for similar questions.
Date published: 2015-09-23
What is the hight from the top of the platform to the top of the hand rail, in inches?
12.5 inches
Date published: 2015-09-23