detailsback to top
q & aback to top
Do you have questions about this product? 4 easy ways to get the answers you need:
get answers from real customers and in-house experts with AnswerBox.
Q:So after the last person boards the pontoon, how do you stow the ladder?Asked on 7/4/2014 by cato
A:The track for the ladder is flush with the front of the boat, so someone should just be able to lean over the edge and grab the ladder by the step, pull it horzontal, then slide it in.Answered on 7/17/2014 by Anonymous
Q:What are the dimensions of the ladder?
I have a triple pontoon and want to determine fit.
Thank youAsked on 7/1/2014 by Mac from Freedom NH
A:48"L x 15-13/16"W x 5-1/2"DAnswered on 7/1/2014 by Product Expert from Overtons
Q:How does this ladder deploy and retract? Is it on a hinge? Can it be raised and lowered from within the boat or does the operator need to be under the boat?Asked on 5/30/2014 by Tim
A:There is a pivot point for the lader to pivot down once extended. You must pull straight out from the front of the ladder to operated it. Depending on your setup, this most likely could NOT be done from insdie the boat.Answered on 6/2/2014 by Anonymous
Q:Our pontoon has a full rolled metal underside (no exposed wood). How do I attach the ladder? I can drill the holes, but how would I access the back of the screws to attach the washer and bolts?Asked on 4/30/2014 by L Horton from Lake Lure, NC
A:If your boat is skinned underneath you will have to remove or lower a section of the aluminum skin to mount this ladder.This ladder comes with 4 bolts and lock nuts. Two of the bolts will go on the bow of your boat, on the section you can see in the photo. The other two will go on the end of the section of the ladder bracket that is mounted under the boat. Since the distance between pontoon cross member vary none of the holes are pre-drilled in the ladder bracket.
Another option is to use self tapping machine screws versus the supplied bolts and nuts. If you can locate your cross members that are under the aluminum skin you can drill pilot holes and then use a large screw or lag bolt that is made for metal or aluminum to secure the ladder bracket. It is very important that you use large enough screws and the screws pull tight into the cross member so the ladder will be secure enough to hold the intended weight of the ladder.
Hopefully this information was helpful and please call 1-800-334-6541 if you need additional information.Answered on 4/30/2014 by Product Expert from Overtons
Q:What is the brand name of this ladderAsked on 7/31/2012 by Mark from Illinois
A:Overton's in house brand is the brand name of this ladder!Answered on 11/7/2012 by Justin M. from Overton's
Q:If you have a large front deck with no boat sides within reach, can you get up the ladder without grabbing on to something?Asked on 5/16/2012 by Need a new ladder from Sacramento Ca.
A:If you have good balanceAnswered on 10/1/2012 by Anonymous
Q:Do you have to remove the ladder to trailer your pontoon? If so, is it easy or hard to do?Asked on 4/13/2012 by Mike