detailsback to top
q & aback to top
Do you have questions about this product? 4 easy ways to get the answers you need:
get answers from real customers and in-house experts with AnswerBox.
Q:will this fit a factory ski pylon for an 83 ski nautique?Asked on 6/17/2012 by patrick from savannah,
Q:will this work on 2003 SEA DOO SPORTSTER ?Asked on 6/11/2012 by Anonymous
Q:Is there a base that you would have to mount to the boatAsked on 2/2/2012 by Anonymous from west palm beach Fl
Q:Is there a base on the pole that you drill and attach to the floor of the boat?Asked on 8/20/2011 by Anonymous
Q:I have a 1999 23' Sea Ray bowrider. Will this product work with the table and seat extention pylon, which is 21/4" OD.Asked on 5/24/2011 by John from Norris Lake TN
Q:Will this pole fit a '78 Ski Nautique?Asked on 5/23/2011 by Anonymous
Q:is there a version about 1/2 this height?Asked on 5/3/2011 by water song from waterford, wi
Q:What stops the pole from bending to the side when I take my wakeboard wide? I don't see any side to side support.Asked on 4/2/2011 by Anonymous from Az
A:There's not much stress on the pole when pulling against the side of the boat as opposed to directly behind the boat. Plus, the boat will rock over to dampen what stress there is when starting from a wide out position. This isn't for advanced tricks but an economical conversion of a water-ski tow boat to a basic wake-boarder's wake-boat.
A $320 mod is better than a $32,000 boat trade...at least for me.Answered on 6/14/2011 by DragonNester from East TN
Q:HI i have a 1988 Ski Centurion.. i bought a pole that is 2 1/2 inches for the inside diameter but 3' total and it does not fit on my existing pylon. Is your pole wider? 3"from the inside diameter ? If so that means it will fit? if not.. how can i get it to fit my pylon?
thank uAsked on 8/25/2010 by ang from folsom, ca
Q:hello i have a new mirro craft dual impact with a factory, removeable pylon at the rear of the boat just ahead of the out board motor. will this work for me?Asked on 12/12/2009 by Anonymous
A:If your factory pylon is 2.5 inches in diameter then it will work.Answered on 12/17/2009 by Justin from Overton's Technician