Enter or verify that code LABORDAY is in your cart at checkout, and a 10% discount will be applied to your order over $100, a 15% discount will be applied to your order over $200, or a 20% discount will be applied to your order over $300. Your savings will be based on the merchandise total only, excluding shipping, handling, additional freight, and taxes. This offer can not be combined with any other offer. Other restrictions and exclusions may apply. Offer expires at 11:59pm ET on 9/1/14. Click here for full offer details >
Product DescriptionThe unique high-rake, progressive pitch configuration is designed to help most boats achieve their best overall performance at all throttle levels; low end, mid-range and top end. Manufactured using a durable 15-5 ph one piece stainless steel casting, then polished to a gleaming mirror-like finish. Your prop is one of the essential links between your boat and the water. Carefully choose the prop that will best suit your application.Mercury/Mariner/Force O/B All V-6 O/B's except Mariner Magnum II, and Mercury XR-4 series.Mercruiser Sterndrive:All Mercruiser I, Alpha I, and Bravo I sterndrives. For the props above with the first digits of "ST103 and ST104" use Quicksilver #13171 thrust washer (Overton's part #24220). Important: These recommendations are for single engine installations only. For most twin engine installations, it is necessary to increase the pitch by 4". Warning: Due to the performance enhancing nature of the design, Quicksilver Trim Tab#. 46399A1 or AP 4004 (Overton's part #38459) MUST be used to avoid damage and/or injury. Exception: With Mariner Magnum II and Mercury XR-4 O/B's, use Quicksilver Anode Plate #. 15300 or equivalent. Note: 1997 and newer Mercury/Mariner O/B with 150hp plus or any Mercruiser I/O will need an aft washer (Overton's part #23395) for proper installation.