detailsback to top
Approximately one quart of primer is required for every gallon of Overton's Rubberized Nonskid Coating.
q & aback to top
Do you have questions about this product? 4 easy ways to get the answers you need:
get answers from real customers and in-house experts with AnswerBox.
Q:I am considering replacing all the carpet in my fish and ski with Tuff Coat. I have a lot of little bare feet in my boat often so I need to know if it gets very hot when in the sun.Asked on 9/24/2013 by ibassfish from Bedford, TX
Q:I recently applied this product on fiberglass and I have a few areas that are bubbling up/peeling. What is recommended to fix these areas?Asked on 4/12/2011 by 1800Bowrider from Belle Fourche, South Dakota
A:Some cleaners will have a reaction of this sort. If this is an area that you had to use cleaner on before applying the tuff coat this could explain the bubbling occurrence. Unfortunately the best thing to do is to remove the coating from these areas and reapply it after washing the areas with water to remove any chemicals that may be present underneath.Answered on 6/8/2011 by Justin from Overtons
Q:Will this product stick to a epoxy boat floor?Asked on 3/8/2011 by creteus from Atlanta
A:You will have to use the water based epoxy primer along with this product no matter what surface you are applying it to. Yes it will work for epoxy boat decks.Answered on 3/16/2011 by Justin from Overton's
Q:1. What air temp can this product be used in?
2. What is cure time ?
3. How dry does the plywood need to be on the deck of my poontoon boat ?
4. Is is water clean up ? If not what does clean it up ?
5. Any warrenty for fading, cracking, etc ?Asked on 1/19/2010 by john from waco texas
A:I would have to ask you to call our tech department at 1-888-683-7866 to discuss the details you are seeking.Answered on 1/25/2010 by Bryant from Tech
Q:I recently had a carpet put on the floor of my pontoon boat (2 years). It is impossible to care for and keep clean.
I definitely want to get this product to replace the carpet later on this spring. Can you tell me how to remove the carpet and adhesive to prepare for this primer and coating product?Asked on 1/3/2010 by Grandnet from Julian, NC
A:If it was glued down then you should remove anything off of the deck that would keep the carpet from coming up. Then find a good starting point, usually in a corner and pull it up as carefully as possible. Then just lightly sand the top of the deck before you apply the tuff coat primer.Answered on 1/6/2010 by Justin from Overton's Technician
Q:Does this product adhere well to aluminum?Asked on 1/2/2010 by Anonymous
A:You will use the metal primer for aluminum and steel and that adheres very well to metal and the actual tuff coat non-skid coating will adhere directly to the primer. You will have to use the primer for the non-skid coating to work out properly.Answered on 1/5/2010 by Justin from Overton's Technician
Q:Yes, I have a 14ft Jon Boat Alum. and I would like to use this on the inside. Will one Gallon of Overton's Rubberized Nonskid Marine Coating, along with 1 qt. of Primer be enough? Boat size 14'Semi-V with 3' bottom sides 20" in height.Asked on 12/30/2009 by Norm from Bruceton, TN
A:1 quart of primer and one gallon of tuff coat (2 coats tuff coat needed for proper application) cover 40-50 square feet. Square footage is found by multiplying the length by the width. Use that to find out how much square feet you have, and then divide by 40 square feet per gallon and that is how many gallons you will need for one coat.Answered on 1/6/2010 by Justin from Overton's Technician
Q:Do you need to apply 2 coats, and if so do need to reapply the primer over the first coat, or just apply the 2nd coat over the first coat.Asked on 12/29/2009 by Yourboy from Lexington, SC
A:No, just apply 1 coat. You need to apply 1 thick coat.Answered on 12/29/2009 by Bryant from Tech
Q:The rubber on the underside of my snap in carpet is dry rotted. The carpet is in great shape. Is there a product that i can use to apply a new rubber coat on the underside of my boat carpet?Asked on 10/30/2009 by BJM from Palm Harbor , FL
A:There is no product that I know of to replace the rubber for the carpet. Sorry that we could not be of more help.Answered on 11/4/2009 by Chad @ Overton's from Greenville, NC
A:We do not have anything like that, but I am not sure if something like that exists.Answered on 11/12/2009 by Justin M. from Overton's Technician
Q:Once applied do you need a specialized cleaner for spills, stains etc? Can you use household cleaners to maintain or clean it or will it hurt the flooring material?Asked on 10/19/2009 by RC from Fresno, Ca
A:A mild soap and water solution should be fine.Answered on 10/21/2009 by marty from overtons tech